BJ Motors is proud to offer this amazing 1986 Chevrolet C/K 10 Custom Resto-Mod!
This beautiful K10 has been upgraded to the point where no bolt or nut went untouched! This is a true turn-key show truck or offroad beast that is ready for any cruise or local car show. Almost everything on the truck has been replaced or upgraded to make it the ultimate Squarebody truck.
Sitting on a 9″ suspenion lift and 3″ body lift, the truck is powered by an upgraded 350 V8 that was bored to a 355. The 20×12 Raceline Wheels and 40″ Toyo tires are turned by way of a Dana 60 Front Axle, as well as Full Float 14-Bolt Rear Axle with a Detroit Locker. This beauty has been upgraded every which way and is ready for any application. Please see below for the full list of upgrades on this amazing truck!Highlights:
- 150k+ miles on the chassis, 6,293 miles since the restoration.
- Frame-off restoration, 89-91 front clip swap.
- Chassis sandblasted and painted.
- Undercoating sprayed under cab.
- Bedliner sprayed inside bed and under bed along with the wheel wells.
- Full exterior paint job.
Drivetrain and lift:
- Dana 60 front axle (completely rebuilt with new seals, etc.).
- Full Float 14 Bolt rear axle with Detroit Locker (freshly sealed with new gear lube August 2020).
- 4.10 gear ratios.
- 9″ Total suspension lift, 8 Skyjacker springs, 1 ORD zero rate add-a-leaf.
- 3″ Body Lift.
- Bumpers and gas tanks moved up to close gap from body lift.
- 40×15.50r20 Toyo MT tires
- Raceline 20×12 wheels.
- Off Road Design crossover steering kit.
- PSC Hydraulic ram assist kit.
- Custom built rear driveshaft with double cardon joint built to 1 ton specs 1350 u-joints.
- Custom Traction Bars.
- Custom driveshaft safety loop.
- Custom shock mounts and hoops.
- Bilstein 5160 remote reservoir shocks.
- 350 engine machined and bored to 355ci.
- SCAT rotation assembly.
- Keith Black 10.5:1 pistons
- Edelbrock performer top end kit (hydraulic flat tapet cam, timing gear, valvetrain and cylinder heads).
- Edelbrock Performer RPM Air Gap intake manifold.
- Holley Avenger 670cfm carb.
- 2 Wilson manifolds spacer with 6 K&N filter.
- Street Fire by MSD ignition box with rev limit set to 6,000RPM.
- MSD Blaster 2 coil.
- MSD Pro Billet Distributor.
- MSD Wires.
- Stainless headers 1-5/8 primaries, 3 H-pipe to 40 series Flowmaster mufflers 2.5 outlet.
- Be Cool Aluminum Radiator, B&M oil cooler for power steering fluid.
- Derale Dual 12 electric fans.
- March Pulleys.
- 150amp Powermaster Alternator with Optima Red Top battery.
- SSBC vacuum pump.
- SM465 4 speed transmission
- Centerforce dual friction clutch.
Miscellaneous and interior:
- Hornblasters conductor special train horn kit, 4 trumpets, 155psi compressor and 2 gallon tank.
- Custom built stainless steel roll cage.
- Full Autometer Gauges, 8 in total.
- Grant Steering wheel.
- Push button ignition.
- Pioneer head unit.
- Headliner with four (4) Polk Audio speakers.
- Two 10 RA Audio Subwoofers.
- JL Audio 500 watt, 4 channel amp.
- Kicker Class D 475 watt mono amplifier.
- Sound dampening used throughout the truck.
- Fully rewired entire truck with custom harness.
Location: Tomball, Texas, United States
Price: $36,995 <- check here if it's still available
More info: Full listing and Contact details
Originally listed on November 23, 2020. Note that older listings are displayed for reference and will most probably not be available.